| Lindab Installation |
Outlets
Thanks to the unique design of the system, outlets can be placed anywhere along the gutter without the need to break the running length in order to accommodate a downpipe. The design of the outlet is such that it will sllow an unrestricted flow to the downpipe and is simply clipped over the gutter section and snapped into place. |  |
Jointing
Gutter joint connectors are easily and quickly fitted using a unique press-on clip. No tools required. |  |
Stop Ends
These neat compact accessories are self-locking and are simply pushed into place with the palm of the hand. |  |
Downpipes
These fit flush into each other to provide uninterrupted flow to the drain and are held in place by snap-lock holders mounted on the wall. Should the occasion demand they can be released without having to undo any screws. |  |
Accessories
A comprehensive range of fittings including inner and outer angles, branches, shoes, drain and leaf traps, is available. |  |
Installation
Note: in order to provide adequate flow, gutters should always be installed so that the slope to the outlet is not less than 2.5mm per linear metre. The total length of the run to a single downpipe should not exceed 10 metres. Gutters longer than this should slope from the middle to downpipes at either end. |
